Cold Air Intake Kit

• Increases horsepower and torque.
• Improves throttle response.
• Improves fuel economy.
• Enhances engine's volumetric efficiency.
• Enhances intake sound (induction roar).
• Installs in an hour (does not require bumper or headlight removal).
• Maintains all factory emissions components inc air temp sensor.
• Fits both manual and automatic transmissions.
• Unique thermal barrier construction ensures low inlet temperatures.
• Fully compatible and complimentary with aftermarket remap/tune.
• Vehicles fitted with these cold air intake kit do not require ECU tuning of any kind to achieve results, this is a simple bolt on modification.
• Back to back testing has proven up to half a second improvement in the 0-100 KPH sprint times.
• Fitting time normally takes no longer than 30-60 minutes.
• Commodore V6 3.6L Models Picks up cold air from behind the headlamp and behind front bumper bar.

Kit Contains:

• 2 x Aluminium Tubes
• 3 x Hi Temp Black Silicon Tubing
• 6 x Billet High Performance Clamps (Except For Throttle Body Clamp - Factory one is used)
• Full Instructions & Images
• Re-Usable / Washable Cotton High Flow Air Cleaner Pod - Equivlent to K&N

Suits:

• Holden All VE V6 3.6 Litre Ute / Sedan / Wagon
• Alloytec & some Sidi (Email Us for Compatibility)
• Commodore
• SV6
• Thunder
• Omega
• Berlina
• Calais
• WM Statesman & Caprice V6

NB: Please note that the Billet Clamps displayed through-out this listing are NOT supplied - and were the customers own clamps - We do however supply high quality banded clamps for this kit.

Furthermore, this kit is not supplied with a MAF Sensor (Mass Air Flow - Sensor), You use your own factory unit.

PLEASE NOTE:
Some 2011 models require that you remove your MAF (mass air flow meter) sensor from your factory air box lid neck – basically cut the neck off which contains the MAF and install between the primary and secondary pipes supplied.

If your factory air box has the installed IAT (intake air temperature sensor).
Please remove this from the air box and install just inside the neck of the new air filter. Also make a thin groove in the neck of the filter for the loom to lay in